DIY ATmega328P Programmer Development Board for Arduino UNO R3

1,100.00

Out of stock

Description

  • – It has been burned Arduino UNO bootloader
  • – It uses a locking seat, so it is easy to replace the chip.
  • – You can use FT232 USB to TTL module, CH340G module, to burn the program.
  • – 100% compatible with Arduino UNO R3 program, expansion shields, development environment IDE.
  • – Microcontrollers: ATmega328P-PU
  • – Operating voltage: 5V
  • – IO interface logic voltage: 5V
  • – Operating Current: 500mA (max)
  • – Digital I / O pins: 14 (of which 6 can provide PWM output)
  • – Analog input pins: 6
  • – Clock frequency: 16MHz
  • – On-board test indicator LED, and the beginners can program to control it.
  • – Onboard power indicator.
  • – Bootloader burning Interface: ICSP
  • – Programming Interface: GND, 5V, RX, TX, DTR

Reviews

There are no reviews yet.

Be the first to review “DIY ATmega328P Programmer Development Board for Arduino UNO R3”

Your email address will not be published.

X