CW-S01 PWM Stepper Motor Driver Simple Controller Speed Controller Forward and Reverse Control Pulse Generation

Features:
When the controller generates a pulse frequency signal, it can be used as a signal for the stepper driver. Drivers are also required to control the stepper motor.
This ple controller + Stepper motor driver + Stepper motor + DC can form a ple control platform.
The controller can generate a pulse frequency signal, it can also be generated. PWM Signal pulse duration. There is a bouncing needle on the board., You can set options Select, the default setting should generate a pulse frequency signal.
REQ It generates a pulse frequency.
When the controller generates a frequency pulse signal, has a high, low frequency signal can be selected by a jumping needle, the frequency parameters are approximately:
High: 5.8 kHz-127 kHz
V: 590 Hz-15.8 kHz
Low: 82 Hz-2.3 kHz,
Frequency measurement: the number of available negative terminals (GND) two ports.
2 Power input group, 2 groups A can only be connected to a group of power sources. the recommended is 15 V. receive2 bit terminal , neither positive nor negative, we must accept the opposite ..
One group is a connected to DC.15-160VDC, the recommended working voltage15-80VDCAll right.
The other group is5-12VDC. when used in conjunction with the driver, it is recommended that minimum12V be used, do not use 5V power, 5V not too long, positive “5-12 Venter”, negative “common cathode end”.
Connection instructions: Wiring each connection port, instructions for the silk screen next to the terminals. It can be connected to a step driver using a regular yin or common yang.