3 Axis CNC Stepper Motor Driver Controller Board 3A TB6560


Out of stock

SKU: 0403 Category:


With Toshiba TB6560AHQ chip – High power, maximum 3.5A drive current .
Professional design, two-stage signal processing, super anti-jamming.
1-1/16 microstep setting – Higher accuracy .
Adjustable drive current settings for each axis – 25%,50%,75%,100% of full current can be set for different stepper motors .
Overload, over-current and over-temperature safety – Full protection for your computer and peripheral equipment .
On board current switching – Power output can be set according to specific user requirement .
Relay spindle interface – Outputs Max. 36V 7.5A for spindle motors or coolant pump (only one device can be powered by this output!)
4 channel inputs interface- Can be used for XYZ limit and emergency stop .
Bipolar constant current chopper drive with non-resonant region .
Full closed-type optical isolation to protect the user’s computer and equipment
Four control inputs (divided into pairs of knives) – Allows setting of limit and emergency stop.
Universal architecture – Supports most parallel software MACH3, KCAM4, EMC2 etc.
Please Note
Please connect the power supply to the power switch of DC 12-36 V
Voltage Selection:
> 12-16V DC power supply for Nema 17 stepper motors
> 16-24V DC power supply for Nema 23 stepper motors
> 24-36V DC power supply for Nema 34 stepper motors
The power output of 12V shall be applied to the radiator fan of 12V
Driver output compatible with 2 or 4 phase, 4,6 or 8 lead stepper motors, 3A max.
Suitable for unipolar or bipolar stepper motors.
Voltage regulated spindle speed controlled by parallel interface as function of supply voltage.


There are no reviews yet.

Be the first to review “3 Axis CNC Stepper Motor Driver Controller Board 3A TB6560”

Your email address will not be published. Required fields are marked *